If you find Newton’s rings in a place in your image with a lot of texture, the editing is much more difficult. They are often most noticeable in parts of your image with a solid color, like the sky, and if this is the case, they can be edited out in Photoshop without too much trouble. If you don’t want to use ANR glass, you can edit Newton’s rings out. It’s not unusual to see a 4 x 5 piece for around $100. The only downside to ANR glass is that it is expensive. ANR glass is textured on one side to limit those reflective artifacts. But there aren’t too many film holders that let you scan borders, so let’s look at some other options.Īnother option is to use anti-newton ring glass. It holds the film off the surface of the scanner, preventing Newton’s rings. One way to combat Newton’s rings is to use a film holder. They occur when your film is sitting directly on the scanning surface. This effect is a result of interference between two reflective surfaces, the scanning surface and your film. They look similar to the pattern that motor oil makes in a puddle. Newton’s rings are swirly patterns that show up on your film scans and can be a total pain to edit out. Related: Intro to Scanning Your Own Film Negatives What are Newton’s Rings? The white paper is guide so I know where to put my negative. Place the film strip emulsion side up on the scanner, and then put a piece of glass on top of the negative. If the emulsion side is face down, it will still scan, but it will be a mirror image of your frame and the border text will be backwards. Placing the film with the emulsion side up will allow the words on your film border to be read the correct way. The emulsion side is the duller side of the film. Then, I place a piece of glass on top of the negative to hold it in place and keep it from curling. I use a pretty simple setup and prefer to put the negatives directly on the glass, emulsion side up. The 35mm mask will scan sprockets, and the 120 mask scans a small amount of the border (but it doesn’t show the entire border). If you’re looking for a film holder that can scan borders, try Lomography’s DigitaLIZA scanning masks. When scanning film borders, you can place the film negative directly on the glass of your scanner, or you can buy a special film holder that will hold the film in place and still show the borders. Setting Up Your Scanner for Scanning the Borders on Your Film Negatives
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |